Carburetor Rebuild Kit w/ Float, Weber HPMX 40-44-48 IDF

Product Description

CARBURETOR REBUILD KIT'S (PAIR) 2-COMPLETE KITS
\nKit #703 Carburetor Rebuild / Overhaul Kit
\n
\nCompatible with Weber 40/44/48/IDF
\n
\nCompatible with EMPI HPMX 40/44
\n
\nThese kits include everything you need to completely service your carburetors, including new a new float and air – fuel screws & springs.
\nThe top gaskets are made from O.E. material to spec.
\nThe base gaskets and top air filter gasket as well as the choke block plate gaskets are cut from U.S.A. Sure Seal material. These are the gaskets you buy after you throw away the original gaskets that are too thick and stiff as cardboard.
\n
\n \n\nEACH KIT INCLUDES:
\n3 – Top Gaskets 40-44-48
\n1 - Air Filter Base
\n1- Early Accelerator Pump Diaphragm
\n1- Late Accelerator Pump Diaphragm – Extended Life
\n1 – Accelerator Pump Diaphragm Spring
\n1- Float
\n1- Needle/Seat with Viton Tip
\n2 – 40mm Base Gaskets
\n2 – 44mm Base Gaskets
\n1 – Choke Block Plate Gasket
\n2 – Air Fuel Volume Mixture Screws, Springs, Cups & O-rings
\n1 – Internal Filter Screen
\n1 – Float Bowl Vent Screen (optional) – (You may need to open your vent slot to use this, depending on your carb top.)
\nAll necessary idle jet O-rings and inlet, pump jet and screen seals to overhaul your unit.
\nPrinted diagram sheet.
\nAlso, universal fuel filter that can be used for ¼” fuel line or cut to5/16” this is a well thought out quality 39-piece kit.
\n
\n703 – Carb rebuild kit, pair (2-kits)